Difference between revisions of "RGB-Pi PLUS Installation"

From RGB-Pi Wiki
Jump to: navigation, search
Line 1: Line 1:
'''Steps'''
+
'''VideoTutorials'''
 +
 
 +
 
 +
English - https://www.youtube.com/watch?v=gGsKI9Mg9-Y
 +
 
 +
[[File:Tumb_p_en.png]]
 +
 
 +
 
 +
Spanish - https://www.youtube.com/watch?v=rIW-G3tiPl0
 +
 
 +
[[File:Tumb_p_es.png]]
 +
 
 +
 
 +
'''Traditional Steps'''
  
 
{|
 
{|

Revision as of 15:43, 8 May 2021

VideoTutorials


English - https://www.youtube.com/watch?v=gGsKI9Mg9-Y

Tumb p en.png


Spanish - https://www.youtube.com/watch?v=rIW-G3tiPl0

File:Tumb p es.png


Traditional Steps

1. If you need to sold the male pins begin putting tin on thecontrary corners of the board and weld first this point to align the pin header, after you can continue welding the rest of contacts.

Points.png

2. Connect the board to te pi in this position, to the outside of the Pi

Posi.png

3. Begin wiring the video pins,, you can use you favorite plug.

Pinout plus.png

4. Create a bundle of cables as seen in the following to be connected to buttons and monitor.

Wiring.jpg

5. That's all! For instructions on how to install RGB-Pi OS, please visit the corresponding section in this wiki.