Difference between revisions of "RGB-Pi PLUS Installation"
Line 13: | Line 13: | ||
|- | |- | ||
|4. Create a bundle of cables as seen in the following to be connected to buttons and monitor. | |4. Create a bundle of cables as seen in the following to be connected to buttons and monitor. | ||
− | [[File: | + | [[File:Wiring.jpg|320px|border]] |
|} | |} |
Revision as of 01:25, 6 August 2020
Steps
1. If you need to sold the male pins begin putting tin on thecontrary corners of the board and weld first this point to align the pin header, after you can continue welding the rest of contacts. |
2. Connect the board to te pi in this position, to the outside of the Pi |
3. Begin wiring the video pins,, you can use you favorite plug. |
4. Create a bundle of cables as seen in the following to be connected to buttons and monitor. |