Difference between revisions of "RGB-Pi PLUS Installation"
(Created page with "Working in progress") |
|||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | '''Steps''' | |
| + | |||
| + | {| | ||
| + | |- | ||
| + | |1. If you need to sold the male pins begin putting tin on thecontrary corners of the board and weld first this point to align the pin header, after you can continue welding the rest of contacts. | ||
| + | [[File:Points.png|320px|border]] | ||
| + | |- | ||
| + | |2. Connect the board to te pi in this position, to the outside of the Pi | ||
| + | [[File:Posi.png|320px|border]] | ||
| + | |- | ||
| + | |3. Begin wiring the video pins,, you can use you favorite plug. | ||
| + | [[File:Pinout_plus.png|320px|border]] | ||
| + | |- | ||
| + | |4. Create a bundle of cables as seen in the following to be connected to buttons and monitor. | ||
| + | [[File:Wiring.jpg|320px|border]] | ||
| + | |- | ||
| + | |5. That's all! For instructions on how to install RGB-Pi OS, please visit the corresponding section in [[OS_Installation|this wiki]]. | ||
| + | |} | ||
Revision as of 02:26, 6 August 2020
Steps
| 1. If you need to sold the male pins begin putting tin on thecontrary corners of the board and weld first this point to align the pin header, after you can continue welding the rest of contacts.
|
| 2. Connect the board to te pi in this position, to the outside of the Pi
|
| 3. Begin wiring the video pins,, you can use you favorite plug.
|
| 4. Create a bundle of cables as seen in the following to be connected to buttons and monitor.
|
| 5. That's all! For instructions on how to install RGB-Pi OS, please visit the corresponding section in this wiki. |
